SeaDoo RX Betriebsanleitung Seite 71
- Seite / 91
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
69
Pre-Season Preparation Chart
NOTE: It is highly recommended that an authorized Sea-Doo dealer perform the
annual safety inspection and factory campaigns in addition to the pre-season
preparation all at the same time.
Before installing new spark plugs, it is suggested to burn the excess BOMBARDIER
LUBE lubricant or equivalent by starting the engine using the old spark plugs.
Safety item covered in the annual safety inspection.
OPERATIONS
TO BE
PERFORMED
BY
GENERAL
Lubrication/corrosion protection Operator
Spark plug replacement
Dealer
ENGINE
Exhaust system condition (fasteners, hoses etc) Dealer
RAVE valve cleaning Dealer
Counterbalance shaft oil level Dealer
Ignition timing Dealer
Air compressor, visual condition of hoses. Check for leaks
CAUTION: Main hose between compressor and fuel rail
may be hot.
Dealer
COOLING SYSTEM Inspection of cooling system hoses and components Dealer
FUEL SYSTEM
Carburetor adjustment (carburetor-equipped models)Dealer
Throttle
and choke (carburetor-equipped models) cable
inspection/adjustment
Dealer
Fuel filter replacement (carburetor-equipped models)Dealer
Fuel injection sensors verification (DI models)Dealer
Fuel system; check valves, lines, fasteners, pressurization
Dealer
Direct injector, check for leakage (DI models)
Dealer
Filler neck, fuel tank and fuel cap condition
Dealer
Fuel tank straps Operator
Refill fuel tank
LUBRICATION
SYSTEM
Oil injection pump adjustment Dealer
Oil filter replacement Dealer
Oil injection reservoir straps Operator
Oil injection reservoir filling Operator
Oil injection pump adjustment and bleeding Dealer
ELECTRICAL
SYSTEM
Battery condition/charging and reinstallation Dealer
Battery, starter connections and routing
Dealer
Monitoring beeper Dealer
Digitally encoded security system Dealer
STEERING
SYSTEM
Steering system adjustment/inspection
Dealer
PROPULSION
SYSTEM
Shifter system condition and cable adjustment (if so equipped)Dealer
VTS (Variable Trim System, if so equipped)Dealer
Propulsion system inspection Dealer
Jet pump oil replacement Dealer
HULL AND BODY Inspection of bailer pick-ups Dealer
smo2000-003a.book Page 69 Thursday, November 11, 1999 10:44 AM
www.SeaDooManuals.net
- Videocassette 3
- Operator’s Guide 3
- Safety Handbook 3
- Piloting 3
- TABLE OF CONTENTS 4
- FOREWORD 7
- SAFETY WARNING 8
- Maintenance 11
- LIST OF DISTRIBUTORS 12
- AMERICA: 2000 SEA-DOO 13
- WATERCRAFT 13
- WARRANTY: 2000 SEA-DOO 15
- REGISTRATION NUMBER LOCATION 17
- Label 1 Label 2 18
- DO NOT BOOST BATTERY 19
- WHILE INSTALLED 19
- IDENTIFICATION NUMBERS 20
- RX/DI Models 21
- GTX DI Models 22
- COMPONENTS FUNCTIONS 24
- 2) Handlebar 25
- 3) Throttle Lever 25
- 4) Engine Start/Stop 25
- All Models 26
- Carburetor-Equipped Models 26
- RX Models 26
- 1. Position indicator 28
- 2. Bow up 28
- 3. Bow down 28
- 10) Glove Box 30
- 11) Fuel Tank Valve 30
- 12) Fuel Tank Cap 30
- 13) Oil Injection Reservoir 30
- Step : Lift 31
- 1. Holder 31
- 19) Seat Latch 32
- 30) Flushing Connector 35
- 31) Bilge Drain Plugs 35
- 32) Jet Pump Nozzle 35
- 33) Reverse Gate 35
- 34) Jet Pump Water Intake 35
- FUEL AND LUBRICATION 36
- Oil Injection System 37
- BREAK-IN PERIOD 38
- DAILY PRE-OPERATION CHECKS 39
- 1. Inspect this area 40
- OPERATING INSTRUCTIONS 42
- 3. Nozzle up 44
- Boarding the Watercraft 45
- A. 90 cm (3 ft) 46
- Starting the Engine 47
- Rough Water or Poor 48
- Visibility Operation 48
- Crossing Waves 48
- Stopping/Docking 49
- Beaching 49
- Shutting Off the Engine 49
- POST-OPERATION CARE 50
- DI Models 51
- Anticorrosion Treatment 52
- SPECIAL PROCEDURES 53
- Capsized Watercraft 54
- Submerged Watercraft 54
- Water-Flooded Engine 54
- Fuel-Flooded Engine 55
- Out of Fuel 56
- Towing the Watercraft in 56
- Low-charge Battery 56
- Condition 56
- MAINTENANCE 57
- Periodic Inspection 58
- Periodic Inspection Chart 59
- WARNING 61
- VTS Adjustment 62
- (if so equipped) 62
- Vacuum Bailer Pick-Ups 62
- General Inspection and 64
- Cleaning 64
- TRAILERING, STORAGE 65
- AND PRE-SEASON PREPARATION 65
- 1. Bleed outlet hose 69
- 1. Engine drain hose 69
- 1. Water regulator valve 69
- 2. Supply hose 69
- Pre-Season Preparation 70
- Pre-Season Preparation Chart 71
- TROUBLESHOOTING 72
- Engine Will Not Start 73
- Engine Overheats 74
- Engine Continually Backfires 74
- Engine Pinging or Knocking 74
- SPECIFICATIONS 76
- SI* METRIC INFORMATION 80
- DEALER IMPRINT AREA 82
- CHANGE OF ADDRESS 83
Verwandte Produkte und Handbücher für Motor SeaDoo RX
Motor SeaDoo GTI LE Bedienungsanleitung
(22 Seiten)
(22 Seiten)
Motor SeaDoo GSI Betriebsanleitung
(105 Seiten)
(105 Seiten)
Motor SeaDoo GTX 4-TEC Betriebsanleitung
(104 Seiten)
(104 Seiten)
Motor SeaDoo GTI LE Spezifikationen
(130 Seiten)
(130 Seiten)
Motor SeaDoo GS Betriebsanleitung
(109 Seiten)
(109 Seiten)
Motor SeaDoo GTI LE RFI Spezifikationen
(121 Seiten)
(121 Seiten)
Motor SeaDoo GSX Limited Bedienungsanleitung
(11 Seiten)
(11 Seiten)
Motor SeaDoo XP DI Betriebsanleitung
(24 Seiten)
(24 Seiten)
Motor SeaDoo SP Wartungshandbuch
(316 Seiten)
(316 Seiten)
Motor SeaDoo GS Betriebsanleitung
(100 Seiten)
(100 Seiten)
Motor SeaDoo GSX Wartungshandbuch
(56 Seiten)
(56 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.047 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern