SeaDoo RX Betriebsanleitung PDF herunterladen (Seite 27)

25

Resetting a Function

To reset a function (such as the chro-

nometer, peak speed, distance, etc.,)

press and hold the SET button for 2

seconds while in the appropriate mode.

The information center includes the

following display areas.

1. General display

2. Message/units display

3. Warning light

4. Fuel level display

5. VTS position indicator (if so equipped)

General Display

The default display is the clock (or

clock/compass if so equipped) unless

another mode has been selected. See

Display Priorities below.

Repeatedly pressing the MODE button

scrolls the following displays: Tachom-

eter, speedometer, peak speed, aver-

age speed, trip meter, hourmeter, wa-

ter temperature, exterior temperature

(if so equipped) and chronometer.

1. Press to change display mode

When you are satisfied with your choice,

stop pressing the button.

Clock: Indicates the actual time in hours

and minutes (hh:mm).

Clock/Compass (if so equipped): Dis-

plays the cardinal points to indicate the

orientation of the watercraft.

Tachometer: Indicates the revolutions

per minute (RPM) of the engine.

Speedometer: Indicates the speed of

watercraft in kilometers per hour (KPH)

or miles per hour (MPH).

Peak Speed: Indicates the top speed

the watercraft reached (PK KPH or PK

MPH).

Average Speed: The information cen-

ter approximately calculates and dis-

plays the average speed (AV KPH or

AV MPH) of the watercraft since the

last engine start.

Trip Meter: The information center ap-

proximately calculates the distance

based on the operation time and the wa-

tercraft speed and displays the result in

kilometers (KM) or miles (MILES).

Hourmeter: Displays the time in hours

of the watercraft usage.

Water Temperature: Displays the wa-

ter temperature (L TEMP) in degrees

Celsius (°C) or Farenheit (°F).

Exterior Temperature (if so equipped):

Displays the exterior air temperature

(E TEMP) in degrees Celsius (°C) or Fahr-

enheit (°F).

Chronometer: Allows to measure an

interval of time in hours and minutes

(hh:mm).

F00L2CY

34

512

F00L2BZ

1



WARNING

Use the compass as a guide only.

Not to be used for navigation pur-

poses.

smo2000-003a.book Page 25 Thursday, November 11, 1999 10:44 AM

www.SeaDooManuals.net

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 90 91

Kommentare zu diesen Handbüchern

Keine Kommentare