SeaDoo RX Betriebsanleitung Seite 55
- Seite / 91
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
53
Carburetor-Equipped Models
Ensure choke lever is completely
pushed in.
DI Models
To prevent fuel to be injected in the en-
gine and engine starting, proceed as
follows.
Depress the throttle lever at full throt-
tle position and HOLD for cranking.
All Models
Crank engine several times to allow wa-
ter to escape from spark plug openings.
DI Models
If water does not completely go out, it
may be necessary to remove the air in-
take silencer then to lean the vehicle so
that water can flow out from throttle
bodies.
All Models
Spray BOMBARDIER LUBE lubricant
or equivalent into spark plug holes.
Crank engine again.
Reinstall spark plugs. Install clean dry
spark plugs if possible. Reconnect ca-
bles.
Start engine normally.
Fuel-Flooded Engine
When the engine does not start after
several attempts, the engine may be
fuel-flooded. Proceed as follows.
Carburetor-Equipped Models
Install the safety lanyard cap on its
switch.
Ensure choke lever is completely pushed
in.
Depress the throttle lever at full throt-
tle position and hold while starting the
engine. Try several times.
DI Models
To prevent fuel to be injected in the en-
gine, proceed as follows.
Depress the throttle lever at full throt-
tle position and HOLD for cranking.
Crank engine several times.
Carburetor-Equipped Models
As soon as the engine starts, release
throttle lever. Do not race engine.
All Models
If it does not work:
Remove spark plug cables and con-
nect them on the grounding device.
Remove spark plugs and dry them using
a rag.
Cover spark plug holes with a rag.
Crank engine several times.
Reinstall spark plugs. Install clean dry
spark plugs if possible. Reconnect ca-
bles.
Start engine as explained above. If en-
gine continues to flood, see an autho-
rized Sea-Doo dealer.
WARNING
Always reconnect spark plug ca-
bles at the same spark plugs
where they come from. The cable
coming out the edge of the electri-
cal box must be connected to the
MAG side spark plug.
WARNING
Always use spark plug cable
grounding device when removing
spark plugs.
WARNING
Always reconnect spark plug ca-
bles at the same spark plugs
where they come from. The cable
coming out the edge of the electri-
cal box must be connected to the
MAG side spark plug.
smo2000-003a.book Page 53 Thursday, November 11, 1999 10:44 AM
www.SeaDooManuals.net
- Videocassette 3
- Operator’s Guide 3
- Safety Handbook 3
- Piloting 3
- TABLE OF CONTENTS 4
- FOREWORD 7
- SAFETY WARNING 8
- Maintenance 11
- LIST OF DISTRIBUTORS 12
- AMERICA: 2000 SEA-DOO 13
- WATERCRAFT 13
- WARRANTY: 2000 SEA-DOO 15
- REGISTRATION NUMBER LOCATION 17
- Label 1 Label 2 18
- DO NOT BOOST BATTERY 19
- WHILE INSTALLED 19
- IDENTIFICATION NUMBERS 20
- RX/DI Models 21
- GTX DI Models 22
- COMPONENTS FUNCTIONS 24
- 2) Handlebar 25
- 3) Throttle Lever 25
- 4) Engine Start/Stop 25
- All Models 26
- Carburetor-Equipped Models 26
- RX Models 26
- 1. Position indicator 28
- 2. Bow up 28
- 3. Bow down 28
- 10) Glove Box 30
- 11) Fuel Tank Valve 30
- 12) Fuel Tank Cap 30
- 13) Oil Injection Reservoir 30
- Step : Lift 31
- 1. Holder 31
- 19) Seat Latch 32
- 30) Flushing Connector 35
- 31) Bilge Drain Plugs 35
- 32) Jet Pump Nozzle 35
- 33) Reverse Gate 35
- 34) Jet Pump Water Intake 35
- FUEL AND LUBRICATION 36
- Oil Injection System 37
- BREAK-IN PERIOD 38
- DAILY PRE-OPERATION CHECKS 39
- 1. Inspect this area 40
- OPERATING INSTRUCTIONS 42
- 3. Nozzle up 44
- Boarding the Watercraft 45
- A. 90 cm (3 ft) 46
- Starting the Engine 47
- Rough Water or Poor 48
- Visibility Operation 48
- Crossing Waves 48
- Stopping/Docking 49
- Beaching 49
- Shutting Off the Engine 49
- POST-OPERATION CARE 50
- DI Models 51
- Anticorrosion Treatment 52
- SPECIAL PROCEDURES 53
- Capsized Watercraft 54
- Submerged Watercraft 54
- Water-Flooded Engine 54
- Fuel-Flooded Engine 55
- Out of Fuel 56
- Towing the Watercraft in 56
- Low-charge Battery 56
- Condition 56
- MAINTENANCE 57
- Periodic Inspection 58
- Periodic Inspection Chart 59
- WARNING 61
- VTS Adjustment 62
- (if so equipped) 62
- Vacuum Bailer Pick-Ups 62
- General Inspection and 64
- Cleaning 64
- TRAILERING, STORAGE 65
- AND PRE-SEASON PREPARATION 65
- 1. Bleed outlet hose 69
- 1. Engine drain hose 69
- 1. Water regulator valve 69
- 2. Supply hose 69
- Pre-Season Preparation 70
- Pre-Season Preparation Chart 71
- TROUBLESHOOTING 72
- Engine Will Not Start 73
- Engine Overheats 74
- Engine Continually Backfires 74
- Engine Pinging or Knocking 74
- SPECIFICATIONS 76
- SI* METRIC INFORMATION 80
- DEALER IMPRINT AREA 82
- CHANGE OF ADDRESS 83
Verwandte Produkte und Handbücher für Motor SeaDoo RX
Motor SeaDoo GTI LE Bedienungsanleitung
(22 Seiten)
(22 Seiten)
Motor SeaDoo GSI Betriebsanleitung
(105 Seiten)
(105 Seiten)
Motor SeaDoo GTX 4-TEC Betriebsanleitung
(104 Seiten)
(104 Seiten)
Motor SeaDoo GTI LE Spezifikationen
(130 Seiten)
(130 Seiten)
Motor SeaDoo GS Betriebsanleitung
(109 Seiten)
(109 Seiten)
Motor SeaDoo GTI LE RFI Spezifikationen
(121 Seiten)
(121 Seiten)
Motor SeaDoo GSX Limited Bedienungsanleitung
(11 Seiten)
(11 Seiten)
Motor SeaDoo XP DI Betriebsanleitung
(24 Seiten)
(24 Seiten)
Motor SeaDoo SP Wartungshandbuch
(316 Seiten)
(316 Seiten)
Motor SeaDoo GS Betriebsanleitung
(100 Seiten)
(100 Seiten)
Motor SeaDoo GSX Wartungshandbuch
(56 Seiten)
(56 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.078 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern