Water should flow out of the fitting
(magneto cooling circuit) and hose
(crankcase heat exchanger). Push
andholdhoseagainstbilgesothat
draining can take place.
1
2
F17E0BY
TYPICAL
1. Fitting
2. Hose
CAUTION:
Water in heat exchang-
er system must be free to flow out.
Should water freeze in engine, se-
vere damage will occur.
Reconnect hose when done.
All Models
Lower hose, push and hold against
bilge as necessary so that draining can
take place.
Reconnect hose when done.
Body Rinsing/Repair
Wash the body with soap and water
solution (only use mild detergent).
Rinse thoroughly with fresh water.
Remove marine organisms from the
hull.
CAUTION:
Never clean fiberglass
andplasticpartswithstrongdeter-
gent, degreasing agent, paint thin-
ner, acetone, etc.
For small gelcoat repairs, refer to an
authorized Sea-Doo dealer. Replace
damaged labels/decals.
Propulsion System
Lubricant in jet pump reservoir should
be drained and reservoir cleaned. Re-
fer to an authorized Sea-Doo dealer for
this operation.
Grease lubrication point(s) of propul-
sion system as explained in MAINTE-
NANCE section.
Fuel System
Sea-Doo fuel stabilizer (or equivalent),
can be added in fuel tank to prevent
fuel deterioration and carburetor gum-
ming. Follow manufacturer's instruc-
tions for proper use.
CAUTION:
Fuel stabilizer should
be added prior to engine lubrication
to ensure fuel system components
protection against varnish deposits.
WARNING
Alwaysstoptheenginebeforere-
fueling. Fuel is flammable and ex-
plosive under certain conditions.
Always work in a well ventilated
area. Do not smoke or allow open
flames or sparks in the vicinity. Fu-
el tank may be pressurized, turn
cap slowly when opening. Never
use an open flame to check fuel
level. When fueling, keep water-
craft level. Do not overfill or top
off the fuel tank and leave water-
craft in the sun. As temperature
increases, fuel expands and might
overflow. Always wipe off any fu-
el spillage from the watercraft. Pe-
riodically verify fuel system. Al-
ways turn the fuel tank valve (if
so equipped) to OFF position when
the watercraft is not in use.
Cooling System Flushing and
Engine Internal Lubr
ication
Refer to procedure in POST-OPERA-
TION CARE.
84
______________________
(11 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern