SeaDoo GTI LE RFI Spezifikationen PDF herunterladen (Seite 51)



WARNING

Do not use any electrical heating

device to heat the cooling system.

Electrical devices may generate

sparks that would ignite fuel va-

pors that might be present in the

bilge causing a fire or an explo-

sion.

– Ensure to drain bilge if water is

present.

Battery



WARNING

Verify tightness of battery cables

to their posts and condition of bat-

tery retaining strap(s)/fasteners.

Do not charge or boost battery

while installed.

Fuel Tank and Oil

Reservoir

With the watercraft horizontal, fill the

fuel tank to specified level.

Check the oil level and refill reservoir

as necessary.

Check fuel tank and oil reservoir retain-

ing straps/fasteners.

Engine Compartment



WARNING

Should any leak or gasoline odor

be present, do not start the en-

gine. Refer to an authorized Sea-

Doo dealer before use.

Steering System

Assisted by another person, check

steering operation for free move-

ment. When the handlebar is horizon-

tal, the jet pump nozzle should be in

the straight ahead position. The rear

edge of side vanes should be pointing

outside of watercraft by approximate-

ly 20°. Ensure the jet pump nozzle

and side vanes pivot easily and in the

same direction as the handlebar.



WARNING

Check handlebar and correspond-

ing steering nozzle operation be-

fore starting. Never turn handle-

bar while someone is nearby rear

of watercraft. Keep away from

steering moving parts (nozzle,

side vanes, linkage etc.).

Throttle System

Check throttle lever for free and

smooth operation. It should return

to its initial position immediately after

it is released.



WARNING

Check throttle lever operation be-

fore starting the engine.

Carburetor-Equipped Models

CAUTION:

Engine can be flooded

if throttle lever is applied several

times when engine is not running.

If engine is flooded, it will not start.

Shifter System

Check reverse gate operation for free

movement. With shift lever in forward

position, the gate should be in upward

position and offering a resistance to

go downward. With the shift lever

in neutral position, gate should be in

middle position. With shift lever in

reverse position, gate should be in

downward position.

50

______________________

www.SeaDooManuals.net

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 120 121

Kommentare zu diesen Handbüchern

Keine Kommentare