
Attach the safety lanyard to your PFD
and snap the cap to its post before
starting the engine.
NOTE: Ifyouhearanythingelsethan
2 short beeps from DESS system, it
indicates a particular condition that
should be corrected. Refer to the
TROUBLESHOOTING section for the
meaning of the coded signal.
WARNING
Before starting the engine, the op-
erator and passengers should al-
ways be properly seated.
Position shift lever to neutral.
Turn the fuel tank valve (if so equipped)
to ON position.
Firmly grip handlebar with your left
hand and place both feet on the foot-
boards.
CAUTION:
Ensure there is at least
90 cm (3 ft) of water underneath
the lowest rear portion of the hull
when all passengers are aboard pri-
or to starting the engine. Otherwise
damage to the impeller or other jet
pump components might occur. Do
not accelerate abruptly.
To start engine, depress and hold the
engine start/stop button. Follow pro-
cedure below for cold or warm engine
starting.
If engine fails to start after 10 seconds,
wait a few seconds then repeat proce-
dure.
CAUTION:
Do not hold start/stop
button more than 30 seconds to
avoid starter overheating. A rest
period should be observed between
the cranking cycles to let starter
cool down. Pay attention not to
discharge battery.
Release engine start/stop button im-
mediately after engine is started.
Carburetor-Equipped Models
Cold Engine
The choke is provided to supply a rich-
er fuel/air mixture when starting a cold
engine.
Fully pull the choke lever and hold
while starting the engine.
F17L18Y
1
1. Fully pull
After engine is started, release choke
lever.
It may be necessary to reapply the
choke and if necessary, slightly apply
throttle to keep engine running.
Warm Engine
The choke does not need to be ap-
plied.
RFI Models
Cold and Warm Engine
Do not depress the throttle lever to
start either a cold or warm engine.
All Models
Riding
Slowly accelerate to reach deeper wa-
ter. Do not apply full throttle until the
engine is warm.
_____________________
57
Kommentare zu diesen Handbüchern