SeaDoo GS Betriebsanleitung Seite 34
- Seite / 109
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
32
NOTE: It may be required to increase
slightly the engine RPM to see the wa-
ter flowing out.
12) Jet Pump Nozzle
It is turned from side to side via rider
input at the handlebar. This provides
watercraft directional control when
engine is running.
Never use nozzle as a supporting point
to board the watercraft or to lift it.
13) Air Intake Opening
This is where air enters to supply the
engine and ventilate the engine com-
partment. If the air intake opening is
kept under water for a long period wa-
ter will get inside bilge.
14) Bilge Drain Plugs
Should water be found in the bilge, it
can be easily drained by unscrewing
the drain plugs.
1. Unscrew
2. Tighten
Tilt the watercraft slightly to the rear
so that the water can completely flow
out of the bilge.
15) Bow and Stern Eyelets
Bow Eyelet
Eyelets can be used for mooring, tow-
ing and as a tie-down point during
transportation.
1. Bow eyelet
This eyelet allows a rope with a hook,
a closes end or an open end to be at-
tached.
-
CAUTION
Should water not flow from out-
let a few seconds after engine
starts, immediately stop engine
and refer to POST-OPERATION
CARE and look for cooling sys-
tem flushing or refer to an autho-
rized Sea-Doo dealer for servicing.
-
CAUTION
If the air intake opening is kept
under water for a long period,
such as turning constantly in
tight circles, water will get inside
bilge, which may cause severe
damage to internal parts of the
engine.
-
CAUTION
Make sure drain plugs are prop-
erly secured prior launching the
watercraft in water.
◆
WARNING
Always make sure bilge drain
plugs are properly tightened.
F02L2FY
1
2
F00L0EY
1
Smo9901b.fm Page 32 Friday, September 4, 1998 10:45 AM
www.SeaDooManuals.net
- All rights reserved 2
- Bombardier Inc. 1998 2
- Videocassette 3
- Operator’s Guide 3
- Safety Handbook 3
- Piloting 3
- TABLE OF CONTENTS 4
- FOREWORD 7
- ◆ SAFETY WARNING 8
- LIST OF DISTRIBUTORS 11
- BOMBARDIER LIMITED WARRANTY: 12
- 1999 SEA-DOO 12
- WATERCRAFT 12
- REGISTRATION NUMBER LOCATION 14
- SP Series 15
- GS Series 16
- XP Series 17
- GTS Series 18
- GT Series 19
- TO CLOSE / POUR FERMER 20
- Emission Control Information 21
- WATERCRAFT IDENTIFICATION 22
- 787 Engine 23
- 947 Engine 23
- COMPONENTS IDENTIFICATION 24
- XP Limited 26
- GTS Model 27
- COMPONENTS FUNCTIONS 30
- 5) Fuel Valve 31
- 6) Safety Lanyard Switch 31
- 7) Docking Eyelets 32
- 8) Seat Latch 32
- 9) Rear Grab Handle 33
- 10) Boarding Pads 33
- 11) Cooling System Bleed 33
- Outlet(s) 33
- 12) Jet Pump Nozzle 34
- 13) Air Intake Opening 34
- 14) Bilge Drain Plugs 34
- 15) Bow and Stern Eyelets 34
- 1. Stern eyelet 35
- 1. VTS button 35
- 1. Bow up 35
- 2. Bow down 35
- 22) Boarding Platform 36
- 23) Seat Strap 36
- 24) Monitoring Beeper 36
- 25) Fuel Gauge/Low Oil 36
- Warning Light 36
- 26) Speedometer 37
- 27) Engine Compartment 37
- 28) Oil Injection Tank Cap 37
- GTI, GTX Limited and GTX RFI 38
- GS, GSX Limited and GSX RFI 38
- 45) Storage Compartment 40
- Cover Safety lock 40
- 46) Handlebar Adjustment 40
- 47) Cargo Cleats 40
- 48) Boarding Step 41
- 49) Info Center Gauge 41
- FUEL AND LUBRICATION 43
- Oil Injection System 44
- BREAK-IN PERIOD 45
- PRE-OPERATION CHECKS 47
- Safety Lanyard and Engine 49
- Start/Stop Button 49
- Clothing 49
- OPERATING INSTRUCTIONS 50
- 2. Bow up 52
- 3. Nozzle up 52
- 3. Nozzle down 53
- Boarding from a Dock or 54
- Starting the Engine 54
- GSX RFI, GTX RFI Models 55
- All Models 55
- Boarding in Deep Water 56
- Rough/Choppy Water 57
- Operation 57
- Crossing Waves 57
- Stopping/Docking 57
- Beaching 58
- Shutting Off the Engine 58
- POST-OPERATION CARE 59
- All Models Except SPX and GTS 60
- SPX and GTS Models 61
- Anticorrosion Treatment 62
- SPECIAL PROCEDURES 63
- Capsized Watercraft 64
- Submerged Watercraft 65
- Towing the Watercraft in 65
- Low-charge Battery 66
- Condition 66
- All Models Except GTX RFI and 67
- GTX RFI and GSX RFI Models 67
- MAINTENANCE 68
- All Models Except XP Limited 69
- Periodic Inspection 70
- Periodic Inspection Chart 71
- 1. Must move freely 72
- Vacuum Bailer Pick-Ups 73
- Water Tank Trap Drains 73
- SPX Model 74
- GSX RFI and GTX RFI Models 75
- General Inspection and 78
- TRANSPORTATION, STORAGE 79
- AND PRE-SEASON PREPARATION 79
- Pre-Season Preparation 84
- TROUBLESHOOTING 86
- SPECIFICATIONS 91
- N.A.: Not Applicable 93
- (47.7 in 101
- SI* METRIC INFORMATION 103
- OTHER PUBLICATIONS AVAILABLE 105
- DEALER IMPRINT AREA 106
- CHANGE OF ADDRESS 107
Verwandte Produkte und Handbücher für Motor SeaDoo GS
Motor SeaDoo GTI LE RFI Spezifikationen
(121 Seiten)
(121 Seiten)
Motor SeaDoo GSX Limited Bedienungsanleitung
(11 Seiten)
(11 Seiten)
Motor SeaDoo XP DI Betriebsanleitung
(24 Seiten)
(24 Seiten)
Motor SeaDoo SP Wartungshandbuch
(316 Seiten)
(316 Seiten)
Motor SeaDoo GS Betriebsanleitung
(100 Seiten)
(100 Seiten)
Motor SeaDoo GSX Wartungshandbuch
(56 Seiten)
(56 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.048 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern