SeaDoo GS Betriebsanleitung Seite 50
- Seite / 109
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
48
OPERATING INSTRUCTIONS
Principle of Operation
Propulsion
The engine is directly coupled to a
drive shaft which, in turn, rotates an
impeller. This impeller is accurately ad-
justed in a housing where the water is
drawn up from underneath the water-
craft. Then the water flows through
the impeller to a venturi. The venturi
accelerates the water and produces
thrust to move the watercraft. De-
pressing the throttle lever increases
engine speed and therefore water-
craft speed.
TYPICAL
Neutral and Reverse
(if applicable)
Neutral and reverse are obtained by
moving a reverse gate, which deviates
the thrust of water.
To obtain neutral position, pull shift le-
ver halfway. The reverse gate will be
in the middle position, deviating half of
the thrust to minimize watercraft move-
ment.
GTS MODEL
1. Shift lever in neutral position
GTI, GTX LIMITED AND GTX RFI MODELS
1. Shift lever in neutral position
◆
WARNING
Always perform the PRE-OPERATION
CHECKS before operating the
watercraft. Become thoroughly
familiar with all controls and the
function of each. Should any con-
trol or instruction not be fully un-
derstood, refer to an authorized
Sea-Doo dealer.
◆
WARNING
Whenever the engine is to be start-
ed, the operator and any passen-
ger(s) should always be sitting on
the watercraft.
F01J3YY
◆
WARNING
When the watercraft is in neutral
position, the drive shaft and im-
peller are turning.
F02L3LY
1
F07L0RY
1
Smo9901b.fm Page 48 Friday, September 4, 1998 10:45 AM
www.SeaDooManuals.net
- All rights reserved 2
- Bombardier Inc. 1998 2
- Videocassette 3
- Operator’s Guide 3
- Safety Handbook 3
- Piloting 3
- TABLE OF CONTENTS 4
- FOREWORD 7
- ◆ SAFETY WARNING 8
- LIST OF DISTRIBUTORS 11
- BOMBARDIER LIMITED WARRANTY: 12
- 1999 SEA-DOO 12
- WATERCRAFT 12
- REGISTRATION NUMBER LOCATION 14
- SP Series 15
- GS Series 16
- XP Series 17
- GTS Series 18
- GT Series 19
- TO CLOSE / POUR FERMER 20
- Emission Control Information 21
- WATERCRAFT IDENTIFICATION 22
- 787 Engine 23
- 947 Engine 23
- COMPONENTS IDENTIFICATION 24
- XP Limited 26
- GTS Model 27
- COMPONENTS FUNCTIONS 30
- 5) Fuel Valve 31
- 6) Safety Lanyard Switch 31
- 7) Docking Eyelets 32
- 8) Seat Latch 32
- 9) Rear Grab Handle 33
- 10) Boarding Pads 33
- 11) Cooling System Bleed 33
- Outlet(s) 33
- 12) Jet Pump Nozzle 34
- 13) Air Intake Opening 34
- 14) Bilge Drain Plugs 34
- 15) Bow and Stern Eyelets 34
- 1. Stern eyelet 35
- 1. VTS button 35
- 1. Bow up 35
- 2. Bow down 35
- 22) Boarding Platform 36
- 23) Seat Strap 36
- 24) Monitoring Beeper 36
- 25) Fuel Gauge/Low Oil 36
- Warning Light 36
- 26) Speedometer 37
- 27) Engine Compartment 37
- 28) Oil Injection Tank Cap 37
- GTI, GTX Limited and GTX RFI 38
- GS, GSX Limited and GSX RFI 38
- 45) Storage Compartment 40
- Cover Safety lock 40
- 46) Handlebar Adjustment 40
- 47) Cargo Cleats 40
- 48) Boarding Step 41
- 49) Info Center Gauge 41
- FUEL AND LUBRICATION 43
- Oil Injection System 44
- BREAK-IN PERIOD 45
- PRE-OPERATION CHECKS 47
- Safety Lanyard and Engine 49
- Start/Stop Button 49
- Clothing 49
- OPERATING INSTRUCTIONS 50
- 2. Bow up 52
- 3. Nozzle up 52
- 3. Nozzle down 53
- Boarding from a Dock or 54
- Starting the Engine 54
- GSX RFI, GTX RFI Models 55
- All Models 55
- Boarding in Deep Water 56
- Rough/Choppy Water 57
- Operation 57
- Crossing Waves 57
- Stopping/Docking 57
- Beaching 58
- Shutting Off the Engine 58
- POST-OPERATION CARE 59
- All Models Except SPX and GTS 60
- SPX and GTS Models 61
- Anticorrosion Treatment 62
- SPECIAL PROCEDURES 63
- Capsized Watercraft 64
- Submerged Watercraft 65
- Towing the Watercraft in 65
- Low-charge Battery 66
- Condition 66
- All Models Except GTX RFI and 67
- GTX RFI and GSX RFI Models 67
- MAINTENANCE 68
- All Models Except XP Limited 69
- Periodic Inspection 70
- Periodic Inspection Chart 71
- 1. Must move freely 72
- Vacuum Bailer Pick-Ups 73
- Water Tank Trap Drains 73
- SPX Model 74
- GSX RFI and GTX RFI Models 75
- General Inspection and 78
- TRANSPORTATION, STORAGE 79
- AND PRE-SEASON PREPARATION 79
- Pre-Season Preparation 84
- TROUBLESHOOTING 86
- SPECIFICATIONS 91
- N.A.: Not Applicable 93
- (47.7 in 101
- SI* METRIC INFORMATION 103
- OTHER PUBLICATIONS AVAILABLE 105
- DEALER IMPRINT AREA 106
- CHANGE OF ADDRESS 107
Verwandte Produkte und Handbücher für Motor SeaDoo GS
Motor SeaDoo GTI LE RFI Spezifikationen
(121 Seiten)
(121 Seiten)
Motor SeaDoo GSX Limited Bedienungsanleitung
(11 Seiten)
(11 Seiten)
Motor SeaDoo XP DI Betriebsanleitung
(24 Seiten)
(24 Seiten)
Motor SeaDoo SP Wartungshandbuch
(316 Seiten)
(316 Seiten)
Motor SeaDoo GS Betriebsanleitung
(100 Seiten)
(100 Seiten)
Motor SeaDoo GSX Wartungshandbuch
(56 Seiten)
(56 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.060 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern