SeaDoo GS Betriebsanleitung Seite 54
- Seite / 109
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
52
Boarding from a Dock or
in Shallow Water
As with any craft, getting aboard
should be done carefully.
When boarding from a dock, slowly
place one foot on the watercraft floor-
board nearest the dock and, at the
same time, transfer the body weight
to the other side in order to balance
the watercraft while holding the han-
dlebar. Then, bring the other foot over
the seat and put it on the other floor-
board. Push the watercraft away from
the dock.
A. 90 cm (3 ft)
In shallow water, board the watercraft
either from the side or the rear.
Starting the Engine
SPX, GS, GTS, and GTI Models
Before unloading the watercraft from
the trailer, it can be started for about
10 seconds to verify proper operation.
Attach the safety lanyard to the opera-
tor’s PFD and snap the cap to the
switch before starting the engine.
Cold Engine
Turn the fuel valve to ON position.
Firmly grip handlebar with your left
hand and place both feet on the floor-
board.
Fully pull the choke lever with your
right hand and depress the start/stop
button.
-
CAUTION
The engine should be started
with at least 90 cm (3 ft) of water
below the hull.
F07A0BY
F01L4WY
A
◆
WARNING
An inexperienced operator should
practice how to get aboard close
to the shore to simulate deep wa-
ter boarding. See Boarding in Deep
Water in this section.
◆
WARNING
Do not touch electrical parts or jet
pump area when engine is run-
ning.
◆
WARNING
Only start the watercraft once all
controls have been checked and
operate properly. Operator and
passenger (if applicable) should
be sitting on the watercraft seat
prior to starting the engine.
Smo9901b.fm Page 52 Friday, September 4, 1998 10:45 AM
www.SeaDooManuals.net
- All rights reserved 2
- Bombardier Inc. 1998 2
- Videocassette 3
- Operator’s Guide 3
- Safety Handbook 3
- Piloting 3
- TABLE OF CONTENTS 4
- FOREWORD 7
- ◆ SAFETY WARNING 8
- LIST OF DISTRIBUTORS 11
- BOMBARDIER LIMITED WARRANTY: 12
- 1999 SEA-DOO 12
- WATERCRAFT 12
- REGISTRATION NUMBER LOCATION 14
- SP Series 15
- GS Series 16
- XP Series 17
- GTS Series 18
- GT Series 19
- TO CLOSE / POUR FERMER 20
- Emission Control Information 21
- WATERCRAFT IDENTIFICATION 22
- 787 Engine 23
- 947 Engine 23
- COMPONENTS IDENTIFICATION 24
- XP Limited 26
- GTS Model 27
- COMPONENTS FUNCTIONS 30
- 5) Fuel Valve 31
- 6) Safety Lanyard Switch 31
- 7) Docking Eyelets 32
- 8) Seat Latch 32
- 9) Rear Grab Handle 33
- 10) Boarding Pads 33
- 11) Cooling System Bleed 33
- Outlet(s) 33
- 12) Jet Pump Nozzle 34
- 13) Air Intake Opening 34
- 14) Bilge Drain Plugs 34
- 15) Bow and Stern Eyelets 34
- 1. Stern eyelet 35
- 1. VTS button 35
- 1. Bow up 35
- 2. Bow down 35
- 22) Boarding Platform 36
- 23) Seat Strap 36
- 24) Monitoring Beeper 36
- 25) Fuel Gauge/Low Oil 36
- Warning Light 36
- 26) Speedometer 37
- 27) Engine Compartment 37
- 28) Oil Injection Tank Cap 37
- GTI, GTX Limited and GTX RFI 38
- GS, GSX Limited and GSX RFI 38
- 45) Storage Compartment 40
- Cover Safety lock 40
- 46) Handlebar Adjustment 40
- 47) Cargo Cleats 40
- 48) Boarding Step 41
- 49) Info Center Gauge 41
- FUEL AND LUBRICATION 43
- Oil Injection System 44
- BREAK-IN PERIOD 45
- PRE-OPERATION CHECKS 47
- Safety Lanyard and Engine 49
- Start/Stop Button 49
- Clothing 49
- OPERATING INSTRUCTIONS 50
- 2. Bow up 52
- 3. Nozzle up 52
- 3. Nozzle down 53
- Boarding from a Dock or 54
- Starting the Engine 54
- GSX RFI, GTX RFI Models 55
- All Models 55
- Boarding in Deep Water 56
- Rough/Choppy Water 57
- Operation 57
- Crossing Waves 57
- Stopping/Docking 57
- Beaching 58
- Shutting Off the Engine 58
- POST-OPERATION CARE 59
- All Models Except SPX and GTS 60
- SPX and GTS Models 61
- Anticorrosion Treatment 62
- SPECIAL PROCEDURES 63
- Capsized Watercraft 64
- Submerged Watercraft 65
- Towing the Watercraft in 65
- Low-charge Battery 66
- Condition 66
- All Models Except GTX RFI and 67
- GTX RFI and GSX RFI Models 67
- MAINTENANCE 68
- All Models Except XP Limited 69
- Periodic Inspection 70
- Periodic Inspection Chart 71
- 1. Must move freely 72
- Vacuum Bailer Pick-Ups 73
- Water Tank Trap Drains 73
- SPX Model 74
- GSX RFI and GTX RFI Models 75
- General Inspection and 78
- TRANSPORTATION, STORAGE 79
- AND PRE-SEASON PREPARATION 79
- Pre-Season Preparation 84
- TROUBLESHOOTING 86
- SPECIFICATIONS 91
- N.A.: Not Applicable 93
- (47.7 in 101
- SI* METRIC INFORMATION 103
- OTHER PUBLICATIONS AVAILABLE 105
- DEALER IMPRINT AREA 106
- CHANGE OF ADDRESS 107
Verwandte Produkte und Handbücher für Motor SeaDoo GS
Motor SeaDoo GTI LE RFI Spezifikationen
(121 Seiten)
(121 Seiten)
Motor SeaDoo GSX Limited Bedienungsanleitung
(11 Seiten)
(11 Seiten)
Motor SeaDoo XP DI Betriebsanleitung
(24 Seiten)
(24 Seiten)
Motor SeaDoo SP Wartungshandbuch
(316 Seiten)
(316 Seiten)
Motor SeaDoo GS Betriebsanleitung
(100 Seiten)
(100 Seiten)
Motor SeaDoo GSX Wartungshandbuch
(56 Seiten)
(56 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.062 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern