SeaDoo GS Betriebsanleitung Seite 74
- Seite / 100
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
72
Install a hose pincher to engine water
inlet hose.
1. Hose pincher installed on the engine water
inlet hose
Temporarily install a short piece of hose
to engine water outlet at cylinder head.
Insert a funnel into hose and pour an-
tifreeze mixed with water in engine un-
til the colored solution appears in the
engine drain hose.
RFI Models
Install a hose pincher to water return
hose of the magneto cooling circuit.
1. Hose pincher to water return hose
Insert a funnel into hose and pour an-
tifreeze mixed with water in engine un-
til the colored solution appears in the
water return hose of the magneto
cooling circuit.
Remove temporary hose and recon-
nect engine water outlet hose.
Remove hose pinchers.
All Models
Most of the antifreeze will drain out
when removing the hose pincher(s).
Use a container to recover it. DISPOSE
ANTIFREEZE AS PER YOUR LOCAL
LAWS AND REGULATIONS.
NOTE: Although antifreeze will mainly
drain out, the antifreeze has mixed with
the water that was possibly trapped in
the water jackets and thus preventing
freezing problems.
At pre-season preparation, drain the
remaining antifreeze from cooling sys-
tem prior using the watercraft.
The following steps should be per-
formed to provide the watercraft en-
hanced protection.
Clean the bilge with hot water and de-
tergent or with bilge cleaner. Rinse
thoroughly. Lift front end of watercraft
to completely drain bilge. If any repairs
are needed to body or to the hull con-
tact your authorized Sea-Doo dealer.
For paint touch up to mechanical parts
use Bombardier spray paint.
Anticorrosion Treatment
Wipe off any residual water in the en-
gine compartment.
Spray BOMBARDIER LUBE lubricant
or equivalent over metallic compo-
nents in engine compartment.
Lubricate the throttle cable with BOM-
BARDIER LUBE lubricant or equiva-
lent.
F06E0FY
1
F07E07Y
1
smo2001-002a.book Page 72 Wednesday, June 7, 2000 3:57 PM
www.SeaDooManuals.net
- TABLE OF CONTENTS 4
- FOREWORD 7
- SAFETY WARNING 8
- Maintenance 11
- LIST OF DISTRIBUTORS 12
- AMERICA: SEA-DOO 13
- WATERCRAFT 13
- 5. LIMITATIONS OF LIABILITY 14
- 6. TRANSFER 14
- 7. CONSUMER ASSISTANCE 14
- WARRANTY: SEA-DOO 15
- REGISTRATION NUMBER LOCATION 17
- GS and GSX RFI Models 18
- GTS Models 19
- GTI Models 20
- GS, GTS AND GTI MODELS 21
- RFI MODELS 21
- GS AND GSX RFI MODELS 21
- GTS MODELS 21
- DO NOT BOOST BATTERY 22
- WHILE INSTALLED 22
- IDENTIFICATION NUMBERS 23
- 787 Engine 24
- COMPONENTS FUNCTIONS 29
- 1. Engine start/stop button 30
- 1. VTS button 30
- 1. Low oil warning light 31
- 11) Glove Box 32
- (if so equipped) 32
- 1. Dipstick 33
- 20) Air Intake Opening 35
- 21) Rear Vent Grills 35
- 22) Seat Strap 35
- 23) Seat Latch 35
- 1. Bow eyelet 36
- 1. Stern eyelet 36
- 1. Mooring cleats 36
- 32) Boarding Step 37
- 33) Cooling System Bleed 37
- 1. Unscrew 38
- 2. Tighten 38
- TYPICAL 38
- 1. Water intake 38
- FUEL AND LUBRICATION 39
- Recommended Oil 40
- Oil Injection System 40
- BREAK-IN PERIOD 41
- DAILY PRE-OPERATION CHECKS 42
- 1. Inspect this area 43
- OPERATING INSTRUCTIONS 45
- 2. Bow up 47
- 3. Nozzle up 47
- Boarding the Watercraft 48
- A. 90 cm (3 ft) 49
- Starting the Engine 50
- Rough Water or Poor 51
- Visibility Operation 51
- Crossing Waves 51
- Stopping/Docking 52
- Beaching 52
- Shutting Off the Engine 52
- POST-OPERATION CARE 53
- Anticorrosion Treatment 56
- SPECIAL PROCEDURES 57
- Capsized Watercraft 58
- Submerged Watercraft 58
- Water-Flooded Engine 58
- Fuel-Flooded Engine 59
- Towing the Watercraft in 60
- Low-Charge Battery 60
- Condition 60
- MAINTENANCE 61
- 1. Front tab 62
- 2. Rear mechanism 62
- Periodic Inspection 63
- Periodic Inspection Chart 64
- Throttle and Choke Cable 66
- Inspection 66
- Carburetor Adjustment 66
- Fuel and Oil Filters 66
- Steering Alignment 66
- VTS Adjustment 67
- Vacuum Bailer Pick-Ups 67
- Water Tank Trap Drains 67
- General Inspection and 70
- Cleaning 70
- TRAILERING, STORAGE 71
- AND PRE-SEASON PREPARATION 71
- 1. Disconnect this hose 72
- 1. Fitting 72
- Pre-Season Preparation 75
- TROUBLESHOOTING 77
- Engine Will Not Start 78
- Engine Overheats 79
- Engine Continually Backfires 79
- Engine Pinging or Knocking 79
- SPECIFICATIONS 81
- (43.81 in 83
- N.A.: Not Applicable 85
- (47.7 in 87
- SI* METRIC INFORMATION 89
- CHANGE OF ADDRESS 91
- YEAR MONTH DAY 99
- No. STREET APT 99
Verwandte Produkte und Handbücher für Motor SeaDoo GS
Motor SeaDoo GSX Wartungshandbuch
(56 Seiten)
(56 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.035 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern