SeaDoo SP Wartungshandbuch PDF herunterladen (Seite 94)

Section 04 ENGINE

Sub-Section 05 (EXHAUST SYSTEM)

04-05-4

TUNED PIPE REMOVAL

All Models Except HX and XP

NOTE : For SP series, remove air vent tube

support from body opening.

Disconnect water inlet hose and water injection

hose.

Disconnect tuned pipe bleed hose.

TYPICAL

1. Bleed hose removed

2. Injection hose removed

3. Inlet hose removed

Cut tie rap retaining together engine and tuned

pipe bleed hoses (if applicable).

1, Collar

Loosen exhaust hose collar at tuned pipe outlet.

2,13, Strap and Muffler

Disconnect strap retaining muffler.

3, Hose

Remove exhaust hose from tuned pipe by pulling

muffler.

4,22, Clamp

Remove clamp from tuned pipe (except SP mod-

el).

5, Tuned Pipe Cone.

Remove tuned pipe cone (except SP model).

6, Screw

Remove tuned pipe retaining screw(s) from ex-

haust manifold side.

7,8,9, Screw, Nut and Flat Washer

Remove screws, nut and flat washers from tuned

pipe flange.

NOTE : Slightly lift tuned pipe to release nut

as necessary. Take care not drop nut and flat

washer.

11, Tuned Pipe Head

Withdraw tuned pipe in a forward and rotating

movement.

HX Model Only

NOTE : It is possible to remove the tuned

pipe head and cone at the same time. If

such is the case, disconnect only the water outlet

hose at cylinder head and do not remove the

clamp retaining tuned pipe head to tuned pipe

cone.

Disconnect water inlet hose at tuned pipe head.

Disconnect water injection hose at tuned pipe

cone.

Disconnect bleed hose on top of tuned pipe head.

4, Clamp

Remove clamp retaining tuned pipe head to tuned

pipe cone (if desired).

7,8,9, Screw Nut and Flat Washer

Remove screws, nut and flat washers from tuned

pipe head flange.

10, Tuned Pipe Head

Remove tuned pipe head.

1,3,6, Collar, Hose and Screw

Loosen exhaust hose collar at tuned pipe cone

outlet.

Remove two screws retaining tuned pipe cone

from exhaust manifold.

XP Model Only

Remove air vent tube support from body opening.

Remove electrical box from watercraft. Refer to

ENGINE REMOVAL AND INSTALLATION 04-01.

F01D8NA

1

2

3

www.SeaDooManuals.net

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 315 316

Kommentare zu diesen Handbüchern

Keine Kommentare